Mizone Latex – Waterproofing additive

PRICE INFORMATION

APPLICATION

Mizone ^® Latex is a high-grade emulsion that significantly improves the quality of cement mortars such as:

• Cement mortar (connecting mortar)
• Thin layer of patching mortar
• Waterproof plaster
• Floor screed
• Concrete repair mortar
• Abrasion resistant coating
• Tile adhesive
• Masonry mortar.

FEATURES / ADVANTAGES

Mizone ^® Latex offers the following advantages:

• Excellent adhesion
• Minimize shrinkage, increase elasticity
• Excellent waterproofing
• Increased chemical abrasion resistance, non-toxic.
• Mizone ^® Latex does not emulsify even under highly alkaline conditions.
• Suitable for plasters in contact with drinking water
• High strength floor plaster
• For making filling and patching mortars where thin finish coats are required
• Adhesive for plastering mortar.

CONSTRUCTION INSTRUCTIONS

CONSTRUCTION METHODS / TOOLS

Surface preparation:

Concrete surface must be clean, in good, solid condition, free from grease, cement dust and other adhesive impurities.

Saturate the entire absorbent surface but do not leave standing water.

1. Connection layer

Mixing ratio:

Mix according to the ratio: 1 liter Mizone ^® Latex + 1 liter water + 4 kg cement to create a mortar mixture that can be applied to about 4m².

Construction:

Add cement into the pre-mixed Mizone ^® Latex and water mixture, then mix well until a uniform consistency is achieved, apply this layer of oil slurry to the surface and then pour new concrete or plaster immediately.

2. Plaster

Mixing ratio: Mix according to the ratio: 1 liter Mizone ^® Latex + 3 liters of water, then mix this solution with the cement - sand mixture to create plaster. Adjust the amount of this solution to achieve the required consistency for construction. Cement : sand ratio = 1 : 3 (by mass).

Construction: Apply the plaster layer while the bonding layer is still wet.

Cleaning: Clean all tools and equipment with clean water immediately after use.

Important Instructions:

Always mix cement into the Mizone ^® Latex-water mixture as a bonding agent.

Follow standard maintenance practices, always saturate the work surface but do not allow standing water.

If applying multiple coats, apply while the previous coat is still wet.

BASIC PRODUCT INFORMATION

All specifications in this document are based on laboratory results. Actual measurement data may vary depending on the specific case.

LOCAL RESTRICTIONS

Please note that product performance may vary from country to country due to local requirements. Please refer to local product specifications for exact descriptions of application areas.

ECOLOGY, HEALTH AND SAFETY

Ecology: Do not dispose of in water.

Transport: Non-hazardous

Waste disposal: According to local regulations

Important: Mizone ^® Latex may cause allergic reactions. Take appropriate measures to avoid direct contact with the skin. If the material gets into the eyes, rinse immediately with clean water and seek medical attention.

LEGAL NOTE

The information, and in particular the recommendations relating to the application and end-use of Mizone ^® Latex products, are given in good faith based on Mizen's current knowledge and experience of the products when properly stored, handled and applied under normal conditions in accordance with the recommendations of Mizone ^® Latex. In practical application, we do not warrant that the products will be of a particular use due to differences in materials, substrates and actual site conditions, nor can any legal obligation in relation to us be implied from this information or from any written recommendations, or from any advice given. The user of this product must test to determine whether the product is suitable for the intended use. Mizen reserves the right to change the characteristics of its products. The proprietary rights of third parties must be noted. All orders are accepted only on the basis of our current Terms of Sale. Users should always refer to the product's latest Technical Data Sheet, which we will provide upon request.